- 5 -
relations of the protocol code with the protocol will be listed in Table 2
）
, the version code is V1.0. After 10
seconds, it will be displayed on LCD, the content of input data buffer and the current address will be displayed at
the very end bottom of the screen. As the following picture, the input data is 0000, and the current address is 001.
NB: Please setup the address, protocol and the baud rate of the keyboard same as the dome or Pan/Tilt,
before control it, may the dome or Pan/Tilt will be out of control by communication failure.
7.1.1.
modify the dome address
CAM
z
press
number:
“1-1024”
z
press
key:
CAM
After modify, the area of current address will display the address # inputted
7.1.2.
lens become wide:
WIDE
7.1.3.
lens become tele:
TELE
7.1.4.
focus become far:
FAR
7.1.5.
focus become near:
NEAR
7.1.6.
aperture become opening:
OPEN
7.1.7.
aperture become closing:
CLOSE
7.1.8.
setup the preset position: PRESET
z
press
number:
“1-128”
z
press:
PRESET
7.1.9.
call
preset
position
CALL
z
press
number:
“1-128”
z
press:
CALL
7.1.10.
start up tracking
z
press
number:
“1-6”
z
press:
SHOT
7.1.11.
setup the left point of the line scanning
z
press: AUTO
z
press:
ON
7.1.12.
setup the right point of the line scanning
z
press: AUTO
z
press:
OFF
7.1.13.
running the line scanning
z
press: AUTO
z
press:
SHOT
Explain: some protocols do not need to setup the line scanning, just run the line scanning directly. After running, if
DATA
：
0000 ID
：
001
