Polymerizer POLY AM en v8
7
5. PRACTICAL USE
PRESETTINGS
WAY OF USE
The preparation for the work consists in setting of the
needed time and temperature.
The adjustments are done using the selection buttons -
button
and button
.
After pressing one of these buttons you will see the
current value blinking on the display.
When the indication is blinking, you can change it with
the help of the arrow buttons until you reach the value
required.
To save this value you must press once more the relevant
selection button.
In this way you exit the mode for adjustment of the
parameters and the apparatus switches to the mode
READY FOR WORK.
The polymerization unit has two working temperature
zones which mean that the device can heat at two stages.
For adjustment of the middle stage the same buttons
described above are used but they should be kept
pressed for more than 2 seconds.
The setting of the middle stage is made in the same way
as the final stage.
The middle stage is not accomplished either if the
adjusted temperature is 39°C or if the adjusted time is 0
minutes.
Put a flask in the device. Pour as much liquid as needed
to fill the vessel but below the upper hole. Close the lid
till it reaches the stopper. Start the process by pressing
the button
RUN/STOP
.
The process can be discontinued any time by pressing the
button
RUN/STOP
again.
After starting the program you must press the button for
draining of the liquid, the relevant LED flashes and the
liquid will be drained automatically in the end of the
process.
In case you need to drain the liquid manually. This can be
made when the device is not in mode for program
execution. For this purpose the button
should be
pressed. Having emptied the device you must press the
same button again so that the electromagnet valve is
closed.
