VopTel Technology Co., Ltd
Page 52/67
Title
Explanation
Off-hook for
rejection
Used for binding a FXO port with a FXS port. For inound calls to a
FXO port, if the FXS port which binging with the FXO port is in the
state of busy line, the gateway will hang up after hook off according to
the time set by the parameter, so as to refuse the upcoming call. The
duration of off hook is 500~5000 milliseconds, with default of 600
milliseconds.
On-hook protection
time
Protection period following hang up of FXO port. During this period,
gateway ignores any voltage variation of line. Value range is 100~5000
milliseconds, the default is 400 in milliseconds.
Polarity detection.
Choose whether to activate the detection of reverse polarity signal of
FXO port inlet. Note the detection will work only when the trunk
supports polarity reversal.
Busy Detection
Repeat
Gateways will regard the busy tone signal with the repeat times
specified here as hang-up signal. Default is 2, effective range is 2 ~ 5.
On-time
Set duration of busy tone signal, the default is 350 in milliseconds.
Off-time
Set the interval time of busy tone, the default is 350 in milliseconds.
2.6.6
Radius call logs
After login, click the label of “Advanced > RADIUS” to open this interface.
Figure 2-17
Configuration interface of Radius call logs
Table 2-21
Configuration parameter of Radius call logs
Title
Explanation
Primary server
Set IP address and port number of preferred Radius server.
Note: if the port number is not configured yet, please use Radius default
port number of 1813.
Key
Set the share key to be used for encrypted communications between
Radius client and server.
Note: the share key should be configured the same for both client and
server side
Secondary server
Set the IP address and port number of standby Radius server. When the
fault appears in communications between gateway and preferred Radius
server, the gateway will automatically activate standby Radius server.
Note: in case of no configuration of port number, use default port
number of 1813.
