10
English
REMOTE BATTERY
Screwdriver required.
1.
For battery replacement, the remote requires one coin style 3V
CR2032 battery. Always use the correct size and grade of battery for
this product.
2.
To replace battery, open battery door on the back side of the
remote control (you will need to loosen the small screw on door
using a #1 Phillips screwdriver). If necessary, clean the battery
contacts and also those of the device prior to battery installation.
Remove any plastic protection from the battery and place it
in the remote with the + side facing out. Ensure the battery is
installed correctly with regard to polarity. Replace the battery door
and screw.
Note:
Remove battery from the remote control when not in use for an
extended period of time and always remove dead battery immediately
and replace with fresh. Do not store dead battery in remote.
The remote control functions are the same as the control panel on
the tower. The remote requires a line-of-sight path to allow for the
signal to be received by the tower. Position the tower so the receiver
lens (inside the Vornado “V” logo) is visible from the remote control.
Your tower circulator remote includes (1) coin style 3V CR2032 battery.
Battery comes pre-installed. Remove battery pull tab before first use.
CLEANING
Because your tower moves a substantial amount of air, it will need
regular cleaning. If service is required, return your tower to Vornado
(see WARRANTY for instructions).
WARNING: To reduce the risk of electrical shock and injury to
persons, unplug the tower before cleaning.
REGULAR CLEANING
1.
Unplug tower before cleaning.
2.
Use the brush attachment on your household vacuum cleaner to
vacuum any accumulated dust off the tower.
3.
Wipe down the entire tower with a soft cloth.
Note:
Do not use gasoline, thinners, solvents or other chemicals for
cleaning. The motor is permanently lubricated and requires no oiling.
