Vornado FANJR, Instruction Manual

12

English

WARNING:

 To avoid risk of fire, electrical shock, or injury to persons, unplug 

the Air Circulator before removing the grill. 

Tip:

 To prevent scratching, gently cover the tip of a flat screwdriver with a 

soft cloth. 

Place flat screwdriver against the angled section of the grill support tab, 
(as shown) and press outward to allow the grill wire to be released from the 
support tab. Repeat on second and third grill support tab. To reinstall, relocate 
grill wire ends into the support tabs, use the flat screwdriver to flex back the 
support tabs to allow grill to snap into place. Be sure all three grill wire ends 
are engaged.

GRILL REMOVAL

BLADE REMOVAL

WARNING:

 To avoid risk of fire, electrical shock, or injury to persons, make sure 

the Air Circulator is still unplugged before removing the blade. 

It is possible to remove the blade should something accidentally get wrapped 
around the motor shaft. 

VFAN JR: 

Remove the Blade Cap by wedging 

a cloth wrapped screwdriver under the Blade 
Cap. Next, remove the Nut by rotating clock-
wise and then remove the Washer. Pull the fan 
blade straight out from the shaft (Fig. 1). When 
replacing, the Blade can only go on the shaft 
one way. Push the Blade all the way on the shaft 
until it bottoms out. Do not use a hammer as 
this could result in bearing damage. Replace 
the Washer, the Nut, and then just press the 
Blade Cap in place to secure.

VFAN, VFAN SR, VFAN SR Pedestal: 

Unscrew the Blade Cap clockwise (Fig. 
2). Then pull the blade straight out 
from the shaft (Fig. 3). When replac-
ing, the blade can only go on the shaft 
one way. Push the blade all the way on 
the shaft until it bottoms out. Do not 
use a hammer as this could result in 
bearing damage. Replace the Blade Cap.

Fig. 2

Fig. 3

Blade Cap

Fig. 1

Blade Cap Nut

Washer