8
English
For quick assembly, follow these steps:
1.
Place carton on its side on carpeted or other soft surface
and gently slide circulator and all packaging components
out. Remove all packaging and set aside.
2.
Place circulator head face down on soft surface. Align
circulator head, upper pole and lower pole. Make
sure cord is not entangled and is able to move freely
within poles.
3.
Slide lower pole onto upper pole. Using provided hex
wrench, use counterclockwise rotations to remove set
screw from collet. Slide collet onto lower pole until it
stops. Check to make sure holes in collet and pole align.
Replace set screw and tighten clockwise with hex wrench.
To avoid damage to product, be sure set screw is fully
aligned and engaged with hole in lower pole.
DO NOT
overtighten set screw as this may impair your ability to
adjust height.
PEDESTAL ASSEMBLY & ADJUSTMENT
MODEL VFANSRP (VFAN SR PEDESTAL) ONLY — HEX WRENCH REQUIRED (INCLUDED)
WARNING:
The power cord is pre-threaded through upper and lower poles. To avoid damaging the power cord, take care when removing
product from box packaging.
Collet
Yoke Cap
Upper Pole
Lower Pole
Top of Base
Circulator
Head
