G E N E R A L I N F O R M A T I O N
page 1 – 2
HD P3 / Aug 2006
General Information
Introduction
The Vorsis HD P3 Digital Multiband Signal Processor unit occupies one 19”
wide rack space (height 1 3/4”), and is 17.346” deep. The two-channel/stereo audio
processor provides an array of analog/digital inputs and outputs, four-band paramet-
ric EQ, three-band compressor, and tunable filters, along with overall AGC, limiting,
and expansion. All settings can be stored and replayed as password-protected
presets. The front panel display includes input, output, and gain reduction meters.
Remote monitoring and operational control is possible using Ethernet-enabled GUI
software.
The XLR, DB-25, DB-9 and CAT5 connectors located on the rear of chassis give
you maximum installation versatility.
Energizing
Assuming the Vorsis HD P3 Digital Multiband Signal Processor is correctly
rackmounted, you may now energize it by connecting the factory supplied power
cord to the rackmount unit and then plugging it into the AC mains.
Note: To de-energize the Vorsis HD P3, unplug its AC cord from the AC mains.