14. Thread the TOP CAP ADAPTOR into
the TOPCAP. Use a Torque wrench, 28mm
chamferless socket and 13mm Spanner to
torque to
45in.lbs
without loctite.
15. Thread the TOPCAP onto the INNER
SHAFT ASSEMBLY
16. Use a Torque 28mm
chamferless socket on the TOPCAP and a
12mm Spanner on the SPRING COLLAR to
torque to
45in.lbs
without loctite.
DO NOT
EXCEED TORQUE SPECIFICATION.
**It is important that the SPRING COLLAR
be tightened against the TOPCAP. Do not
simply tighten the TOPCAP onto the INNER
SHAFT until the threads bottom out. This
will damage the assembly.
17. If the ADJUSTER DIAL and footnut are
installed already on your FOOT STUD, use
a 1.5mm allen key to unscrew the set screw
in the ADJUSTER DIAL until it slides easily
off.
18. Unscrew the FOOTNUT by hand and
remove it and the CRUSH WASHER from
the assembly.
10
Summary of Contents for Smashpot
Page 1: ...Installation Instructions REV C 1...
Page 3: ...KIT CONTENTS Figure 1 Kit Contents 3...
Page 5: ...5...
Page 11: ...11...
