ADDITIONAL STEP (19)
FOR FOX 36 FORKS ONLY
19. Using a Heat Gun, install additional
50mm length of red Heat Shrink over the
top of existing Heat Shrink on the COIL
SPRING. This step helps prevent noise
from spring deflection due to the larger
diameter stanchion on the Fox 36. NOTE:
NOT NECESSARY ON 36 RHYTHM.
20. The complete Smashpot assembly is
now ready to be inserted into your fork and
should look like the picture above.
PART 4: SMASHPOT INSTALLATION
21. Apply a generous amount of Slick
Honey grease to the COIL SPRING
especially the portion covered in Heat
Shrink. Insert assembly into the fork as
shown. Be careful as the needle adjuster is
small diameter and could be damaged if the
assembly is dropped into the fork lower.
22. Install CRUSH WASHER and
FOOTNUT onto the FOOTSTUD.
12
Summary of Contents for Smashpot
Page 1: ...Installation Instructions REV C 1...
Page 3: ...KIT CONTENTS Figure 1 Kit Contents 3...
Page 5: ...5...
Page 11: ...11...
