REMOVE & REPLACE COIL SPRING
1. Remove TOPCAP using 28mm
chamferless socket.
2. Use a 28mm chamferless socket on the
TOPCAP and a 12mm Spanner on the
SPRING COLLAR to remove the TOPCAP
3. Remove SPRING COLLAR, SPRING
PERCH and COIL SPRING. The INNER
TUBE will fall down inside the stanchion.
Compress the fork fully and you should be
able to grab the INNER TUBE and pull it out
of the stanchion.
4. Thread a gear shift cable through the
hole in the top of the INNER TUBE and
through the new COIL SPRING. The COIL
SPRING should be orientated with the
HEAT SHRINK closest to the top.
5. Use the shift cable to pull the INNER
TUBE up through the COIL SPRING until
the threads of the INNER TUBE are
exposed above the COIL SPRING.
17
Summary of Contents for Smashpot
Page 1: ...Installation Instructions REV C 1...
Page 3: ...KIT CONTENTS Figure 1 Kit Contents 3...
Page 5: ...5...
Page 11: ...11...
