4. Using a 14mm cone wrench on the SEAL
HEAD and a 22mm cone wrench on the
BOTTOM OUT CUP - use a Torque wrench
to torque SEAL HEAD to 75in.lbs without
loctite.
5. Position and install the included length of
HEAT SHRINK just shy of the ports and
extending over the end of the SEAL HEAD
using a heat gun. **
Make sure you do not
cover the ports with Heat Shrink
6. Push INNER TUBE into the OUTER
TUBE assembly as far as possible. Using a
sharp knife or scissors, trim back the Heat
Shrink to be in line with the end of the Seal
Head. (Try not to score the shaft with the
knife but note that scratches are not critical -
it is not a sealing surface.)
7. Install a stack height of MAIN SPRING
SPACERS on the outer tube as required to
suit your fork travel. See Drawing 2 above
7
Summary of Contents for Smashpot
Page 1: ...Installation Instructions REV C 1...
Page 3: ...KIT CONTENTS Figure 1 Kit Contents 3...
Page 5: ...5...
Page 11: ...11...
