and following table for details. For example:
a 160mm travel fork requires 30mm of
MAIN SPRING SPACERS so install 1 x
20mm 1 x 10mm spacer.
MAIN SPRING SPACERS
Fork Travel
(mm)
Spacer Stack Height
(mm)
130
NONE
140
10
150
20
160
30
170
40
180
50
8. Place the acetal SPRING PERCH into
the end of the COIL SPRING. It may fit one
end of the spring better than the other. The
better fitting end will be the top of the spring
as oriented in the fork.
9. Slide the Heat Shrink provided on to the
COIL SPRING , approximately 100mm from
the top end of the spring where the SPRING
PERCH will be fitted.
10. Use a heat gun to heat the Heat Shrink
until it fits snugly over the COIL SPRING.
Once shrunk, trim any excess from the ends
of the Heat Shrink that protrudes inside the
inner diameter of the COIL SPRING. When
complete, check that the spring slides
smoothly over the cartridge OUTER TUBE.
8
Summary of Contents for Smashpot
Page 1: ...Installation Instructions REV C 1...
Page 3: ...KIT CONTENTS Figure 1 Kit Contents 3...
Page 5: ...5...
Page 11: ...11...
