SERIAL NUMBERS
Turbine serial number is engraved on the turbine's confusor's rear plate, and consists of the following
alphanumerical sequence:
1) Turbine type: M
2) Turbine's 9-digit number
Turbine components e.g. generator, magnetic coupling, inverter might have their own serial numbers
assigned by their respective manufacturers.
REGULATIONS AND COMPLIANCE
The turbine components are in full compliance with CE and comply with the requirements of Machinery
Directive 2006/42/EC, Low Voltage Directive 2004/95/EC and Electromagnetic Compatibility Directive
2014/30/EU.
All SETUR turbines and their components have been evaluated against major international standards.
INSTALLATION
REQUIREMENTS
It is the user's responsibility to follow the national and local codes, rules, regulations, as well as the zoning
restrictions.
All SETUR turbines are assumed to be installed under the following standard conditions:
➢
Turbine must be installed by , with a help of, or under a supervision of an experienced professional.
➢
Turbine must be fully submerged in water unless the water flow is routed to the turbine via a pipe.
➢
Turbine must be installed in clean water free of any corrosive and dangerous chemicals, as well as
debris. Turbine can be installed either vertically or horizontally.
➢
Turbine must be safely installed at a properly prepared installation site. The turbine's frame can be
mounted in a variety of ways. To determine the best of them is the user's responsibility.
➢
Turbine must be installed in such a way that it withstands with a safe margin the maximum
anticipated pressure of the water flow.
➢
Turbine must be electrically grounded in full compliance with the national and local codes, rules
and regulations.
➢
The access to the installation site must be via a terrain that allows safe turbine carrying, use of
lifting equipment, pipe, if any, power cable laying, etc.
➢
The user must make sure that the site is not slippery, icy, flooded, exposed to falling rocks or trees
etc. Where such conditions exist, it is the user's responsibility to rectify or avoid.
➢
Turbine must be installed at the site in such a way that prevents any possible physical access by the
general public, especially children.
➢
Appropriate intake screen should be installed to prevent any mechanical damage to the turbine by
any debris that might be in water.
Vortex Hydrokinetics LLC © 2019
SETUR-M User's Manual - Rev. 2M-A
Page 12 of 24
