Vortice ARIANTE 25, Instruction Booklet

7

• Check to see that the power rating of the mains and the wall sockets are

adequate for the maximum power required by the unit, as indicated on the
data plate. If in doubt, contact a qualified electrocution.

• In order to avoid dangerous overheating, the electrical cord should be

completely unwound.

• Do not leave the unit turned on unnecessarily. Disconnect the plug from the

wall socket when the unit is not to be used for a while.

• If the electrical cord becomes damaged, replace it immediately. The type

required is: HO5VVF 2.5A 2X0.5L = 1800 IMG.

Important

• If the unit is dropped or receives a strong blow, no signs of damage may be

noticeable, but the unit could be dangerous to use. In these cases, you
should immediately have the unit inspected by a Vortice Assistance Center.

Operating Instructions

• Unwind the electrical cord located under the unit. Insert the plug into the

wall socket (Fig.2). (Check the data plate for mains suitability.)

• Place the unit in the desired position on the floor, on a table or on any other

flat support surface.

• Select the desired speed by turning knob A (Fig. 3). The speed positions are

marked 

•

, 

• •

, 

•••

, to indicate speeds I , II  and III.

• If desired, start the front grill rotating movement by turning knob B (Fig. 3) to

position 

•

(ON).

NOTE: When the unit is turned off by turning knob A to the 0 position (OFF),
the front grill rotation will also automatically turn off.

• When moving or transporting the unit, use the handles built into the body C

(Fig.4).

Cleaning

• Before doing any cleaning operations, remove the plug from the wall socket.
• Use a soft cloth moistened in a solution of warm water and neutral

detergent. Dry very thoroughly.

NOTE:  DO NOT IMMERGE THE MOTOR IN THE WATER.