ENGLISH
The operating speed is preset during appliance
configuration, and can be selected by pressing the UP
button briefly (1=min. speed, 2=med. speed, 3=max.
speed).
Set required room temperature
(fig.20).
Before proceeding with the steps indicated below, press
the ESC button to exit and return to the initial menu.
The preferred room temperature can be selected as
follows:
- press and hold the SET button
- press the SET button briefly (the current value flashes)
- select the required value using the UP and DOWN
buttons
- press the SET button briefly to retain the setting
- press the ESC button briefly to exit.
Activate “bypass” function
(fig.21)
The purpose of the bypass function is to ventilate the
apartment without heat transfer. With the bypass valve
open, air can be introduced directly from outside, without
passing through the heat exchanger. The flow of air
vented from inside continues to pass through the heat
exchanger.
Before proceeding with the steps indicated below, press
the ESC button to exit and return to the initial menu.
The “bypass” function can be forced by pressing and
holding the ESC button. The corresponding "money box"
icon will light up.
Activate time/outdoor temperature display
(fig.22)
Before proceeding with the steps indicated below, press
the ESC button to exit and return to the initial menu.
The current values of the "time" and "outdoor
temperature" parameters can be viewed in alternation by
pressing the ESC button briefly.
User menu
Before proceeding with the steps indicated below, press
ESC to exit and return to the opening screen.
As a rule, the parameters relative to the various options
are selected by pressing SET (this causes the current
value to blink), then scrolling through the available values
with the UP and DOWN buttons, and pressing SET again
to confirm the new value. The UP and DOWN buttons are
also used to scroll through the different options or
parameters. The main user menu can be viewed by
pressing and holding ESC and SET at one and the same
time. The options of the menu are:
-
PROF
: settings for operation with time profiles:
P1, used to program one period of operation per day,
with a start time, an end time and a fan speed;
esc
set
By-Pass
/ °C
1
2
3
4
5
6
7
FILT
P1
P2
Prg
19
119
HA
esc
set
By-Pass
/ °C
1
2
3
4
5
6
7
FILT
P1
P2
Prg
20
2
20
HA
esc
set
By-Pass
/ °C
1
2
3
4
5
6
7
FILT
P1
P2
Prg
21
2
21
HA
esc
set
By-Pass
/ °C
1
2
3
4
5
6
7
FILT
P1
P2
Prg
22
2
22
HA
esc
set
By-Pass
/ °C
1
2
3
4
5
6
7
FILT
P2
Prg
23
2
23
P1
HA
23
