17
Installation of ventilation ducts and vents
- do not touch the motor when installing the ducts.
- Install the ventilation ducts so as to avoid the situations detailed in fig.5:
(1: excessive curvature; 2: close curvatures; 3: reduction of duct cross-section)
- the diameters of the ducts must be suitably sized: the nozzles typically can have three diameters: 80 100 or
150 mm (fig 6)
- install the ventilation ducts, covering them with
aluminium tape (not supplied) to prevent air leakage.
- install the ventilation ducts so as to maintain a slope
toward the outside to prevent water from entering.
- the ventilation ducts will have to be thermally
insulated.
- noise attenuators (optional) can be applied to ducts to
reduce noise emissions. (fig.7);
- do not install the stale air intake nozzle in bathrooms
or kitchens.
- Iinstall the stale air intake vent if possible in dining
rooms or bedrooms.
- install the stale air intake nozzle at least two metres
away from the inward air supply nozzles if possible.
ENGLISH
Prohibited
(1)Excessive bending
Prohibited
(2)Repeated bending
(3)Reduced diameter of
connection duct
Prohibited
5
6
A
100 (Vort Ariasalus 100)
150 (Vort Ariasalus 200)
A [mm]
B [mm]
80
B
B
7
Summary of Contents for Vort Ariasalus 100
Page 53: ......
