--7--
Declaration of Conformity:
In accordance with the provisions of Directives 2014/35/EU, 2014/30/EU, 2009/19/EC, this
product complies with the following standards or normative documents:
EN55014-1; EN55022 B; EN61000-6-1; EN61000-4-2; EN61000-4-3; EN61000-4-4;
EN62368-1; EN50498.
The product
must not be
disposed of in
the household
waste.
The product is RoHS compliant.
It complies with the directive
2011/65/EU for Reduction of
Hazardous Substances in electrical
and electronic equipment.
Safety Regulations:
The Battery Protector 100 had been designed according to the valid safety regulations.
Appropriate application is restricted to:
•
Deep discharge protection for batteries with the specified nominal voltage.
•
The indicated voltage rates, current rates and cable cross-sections of the cabling.
•
Installation of the indicated fuses near the battery to protect the cabling of the unit.
•
Technically faultless condition.
•
Installation in a well-ventilated room, protected from rain, humidity, dust, aggressive battery gases, as well as in
an environment being free from condensation water.
•
For lithium batteries, the unit is not suitable as substitute for a BMS safety system of the battery!
•
The unit is not applicable as safety relay (emergency off switch) for disconnection of dangerous machines or
drives.
•
Never connect the unit between starter battery and the electric/electronic system of the vehicle.
•
Never use the unit in locations where the risk of gas or dust explosion exists!
•
Observe the safety regulations.
•
Open-air operation of the unit is not allowed.
•
Cables are always to be laid in such a way that damage is excluded. Observe to fasten them tightly.
•
Never lay 12 V (24 cables and 230 V mains supply cables into the same cable conduit (empty conduit).
•
Check live cables or leads periodically for insulation faults, points of break or loosened connections. Occurring
defects must be remedied immediately.
•
The unit is to be disconnected from any connection prior to execution of electrically welding or work on the electric
system.
•
If the non-commercial end-user is not able to recognize the characteristic values being valid for a unit or the
regulations to be observed, a specialist is always to be consulted.
•
The user/buyer is obliged to observe any construction and safety regulations.
•
The unit is not equipped with parts, which can be replaced by the user
.
•
Keep children away from batteries and connections.
•
Observe the safety regulations of the battery manufacturer.
•
Ventilate the battery room.
•
Non-observance may result in injury or material damage.
•
The warranty period is 36 months from the purchase date (against presentation of the sales slip or invoice).
•
The warranty will be void in case of any inappropriate utilisation of the unit, if it is used beyond the technical
specification, in case of improper operation or external intervention. We do not assume any liability for any damage
resulting hereof. The liability exclusion is extended to any service being executed by third, which has not been
ordered by us in writing. Service is to be effected exclusively by VOTRONIC Lauterbach.
