STEAM IRONING
•
Place the iron in a vertical position and set the temperature control
dial at the minimum/low heat setting.
•
Insert the plug into the socket, and then turn the temperature
control dial to the “high heat” marking. The pilot light will come on,
indicating that the iron is heating up.
•
When the pilot light turns off, the set temperature has been
reached and the iron is ready to use.
•
During ironing, the pilot light on the iron automatically switches
on/off as the thermostat maintains the set temperature(you may
continue ironing during this process).
•
Turn the steam control turning knob to the required position.
•
Steam is produced as soon as the iron is held horizontally.
SPRAYING
•
Press the spray button to spray water on clothes, as often as
required.
Note: When using the water spray function, ensure that there is
enough water in the water tank, and you may have to pump the spray
button several times the first time you use the iron in order to start the
spraying function.
BURST OR VERTICAL STEAM IRONING
•
Press the burst of Steam button to generate a powerful burst of
steam that can penetrate the fabrics and smooth the most difficult
and tough creases. Wait for a few seconds before pressing again.
•
By pressing the Burst of Steam Button at intervals you can also
iron vertically (curtain, hung garments, etc.)
Note: The burst steam function can only be used at high temperature.
Stop the emission when the pilot light turns on, and then start ironing
again only after the pilot light has turned off.
DRY IRONING
For ironing without steam, follow the instruction in section “steam
ironing”, however, the steam control turning knob should remain in
position “O” (no steam).
4
Summary of Contents for 8606108251294
Page 70: ...www voxelectronics com ...
