VOX electronics DPS-6220 Operating Instructions Manual Download

Page: 6 / 91

f) Adjust the temperature dial in terms of choosing the kind of fabrics that

you want to iron.
Note: If you want to use the steam ironing, we suggest you to adjust the
temperature dial on MAX.
When the iron operating light indicator goes out the device will be ready
for use.
Note: During the whole operating time, the iron operating light indicator
will go on and off in erratic intervals, this is normal.

g) Adjust the steam jet by turning the steam temperature dial.

To make the steam jet come out, press the steam

trigger

If the steam stops coming out, this is probably because there is no more
water in the tank. In order to continue ironing, follow the instructions of the
paragraph “SUPPLYING WATER WHILE OPERATING”

。

h) ECO mode:

If  need  lower  steam  rate,  long  press  the  power  switch  for  2  seconds,
release  the  power  switch  to  start  ECO  mode  (This  mode  is  based  on
energy  efficiency,  the  steam  rate  is  lower).  For  ECO  mode,  all  the
function is exactly the same as the normal mode, except the steam rate is
smaller, If the user need to exit to the normal mode, long press the power
switch for 2 seconds and release the power switch; If need to  turn off the
iron, please press the power switch.

i) Cleaning system:

Self-clean  Mode  (When  cleaning,  the  steam  hole  of  the  soleplate  will
discharge a lot of sewage, please be prepared well in advance), and the
iron has intelligent reminder for cleaning mode and active cleaning mode
respectively.  The  intelligent  reminder  for  cleaning  mode  means  after
accumulates to 36 hours using, the power indicator will blink and beep for
three  times  to  remind  the  user  to  clean  the  iron,  then  long  press  the
power switch for 6 seconds until the power indicator blink and beep for 3
times again,  this is just the time for pressing the trigger, the iron will enter
into  cleaning  mode  and  begin  to  discharge  the  sewage  from  the  steam
hole  of  the  soleplate;  It  will  automatically  exit  the  cleaning  model  after
cleaning for 1 minute,and the power indicator will stop blinking and beep
for 3 times. If the user need to exit the cleaning mode at any time, please
press 6 second until the power indicator stop blinking and beep for three
times, then cleaning mode is finished.

j) Steam boost:

In normal using the iron, press the steam button continuously by 2 times
in 1 second, and the iron will release a large number of steam to form the
steam explosion in 2 second.

k) The soleplate of iron can only be placed on the insulation silicone pad

(three soft silicone) of the station and can touch with lock, and cannot
touch any other plastic part, otherwise will burn the plastic parts.

When the steam iron is used for the first time after being placed for a long
time, some slight powders will spray out from the soleplate, please do not
spray toward the clothes directly for the first 5 seconds when in every
using.