VOX electronics TRD601W, User Manual

5

EN - 1. SAFETY INFORMATION

For your safety and correct operation of the appliance, read 

this manual carefully before installation and use. Always keep 

these instructions with the appliance even if you move or sell it. 

Users must fully know the operation and safety features of the 

appliance.

The wire connection has to be done by specialized technician.

• 

The manufacturer will not be held liable for any damages resulting 

from incorrect or improper installation.

• 

The minimum safety distance between the cooker top and 

the extractor hood is 650 mm (some models can be installed 

at a lower height, please refer to the paragraphs on working 

dimensions and installation).

• If the instructions for installation for the gas hob specify a greater 

distance, this must be respected. 

• 

Check that the mains voltage corresponds to that indicated on the 

rating plate fixed to the inside of the hood.

• 

Means for disconnection must be incorporated in the fixed wiring 

in accordance with the wiring rules.

• 

For Class I appliances, check that the domestic power supply 

guarantees adequate earthing.

• 

Connect the extractor to the exhaust flue through a pipe of 

minimum diameter 120 mm. The route of the flue must be as short 

as possible.

• 

Regulations concerning the discharge of air have to be fulfilled.

• Do not connect the extractor hood to exhaust ducts carrying 

combustion fumes (boilers, fireplaces, etc.).

• 

If the extractor is used in conjunction with non-electrical appliances 

(e.g. gas burning appliances), a sufficient degree of aeration must 

be guaranteed in the room in order to prevent the backflow of 

exhaust gas. When the cooker hood is used in conjunction with 

appliances supplied with energy other than electric, the negative 

pressure in the room must not exceed 0,04 mbar to prevent fumes 

being drawn back into the room by the cooker hood.

• 

The air must not be discharged into a flue that is used for 

exhausting fumes from appliances burning gas or other fuels.

• If the supply cord is damaged, it must be replaced from the 

manufacturer or its service agent.

• 

Connect the plug to a socket complying with current regulations,