AWARD BIOS SETUP
EM586 / 55
3.12 IDE HDD A
UTO
D
ETECTION
If your system has an IDE hard drive, you can use this utility to detect its parameters and
enter them into the Standard CMOS Setup automatically.
If the auto-detected parameters displayed do not match the ones that should used for
your hard drive, do not accept them. Press the <N> key to reject the values and enter
the correct ones manually on the Standard CMOS Setup screen.
Note : If you are setting up a new hard disk drive (nothing on it) that supports LBA mode,
more than one line will appear in the parameter box, choose the line that lists LBA
for an LBA drive.
Do not choose Large or Normal if the hard disk drive is already fully formatted when you
install it, choose the mode “HDD Low Level Format” to format it.
3.13 H
DD
L
OW
L
EVEL
F
ORMAT
Select and highlight this option press the <Enter> key to enable you to perform the low
level format of hard disk drive.
3.14 S
AVE
& E
XIT
S
ETUP
Select this option and press the <Enter> key to save the new setting information in the
CMOS memory and continue with the booting process.
3.15 E
XIT
W
ITHOUT
S
AVING
Select this option and press the <Enter > key to exit the Setup Utility without recording
any new values or changing old ones.
