11
button after the master volume ([GBL] VALUE2) appears on
the program/value display. “CP” will appear briefly on the
program/value display and the volume can be changed by
using the expression pedal.
Setting the range of the parameter that will be used by
the pedal
Set the range of the effect parameter that will be used by the
expression pedal in the pedal setting mode.
1.
Press and hold the pedal setting button for approximately 1
second.
The mode will switch to the pedal setting mode and the
expression pedal LED will blink.
2.
Set the value when the expression pedal is fully returned upright
with the VALUE 1 knob.
3.
Set the value when the expression pedal is fully pressed down
with the VALUE 2 knob.
The tone will change within the set range when the pedal
is used.
4.
When you finish adjusting your settings, press the pedal setting
button to exit the pedal setting mode.
5.
Enter the edit mode to save the settings.
Page 12 “Saving a program — [WRITE]”
The set range will return to the previous setting if they
are not saved when the program is switched or when the
power is turned off.
If the program is saved after using the expression pedal, the
position of the expression pedal (inclined) will be saved as
the set value.
The following values cannot be saved.
• Volume
• Input level to delay effect [PDL]
• Input level to reverb effect [REV]
• Pitch parameter of [MOD] PITCH SHIFT
To control the volume with the pedal, assign the
master level ([GBL] VALUE 2). To control the input
levels of the reverb and delay effects, assign MIX
parameters ([DLY] VALUE 2 and [REV] VALUE 2).
When a target function of the effect pedal is not available,
“- -” appears briefly on the program/parameter display
and the pedal cannot be set.
Effect/parameter type and parameter value display
In the Edit mode you can switch the effect names or the VALUE
1 and VALUE 2 values indicated with the Program UP/DOWN
pedals. The tuner
LED will light up when the effect name is
indicated, the tuner center LED will light up when VALUE 1
is indicated and the tuner
#
LED will light up when VALUE 2
is indicated.
Checking the values saved in a program (Original Value)
The Original Value LED in the program/value display lets you
check the parameter values of a saved program.
When you use the knob or buttons to modify the value of a
parameter, the Original Value LED will light up when that value
Summary of Contents for StompLab IIB
Page 1: ......
Page 68: ...2012...
