Description and Installation
Installation and Programming Manual
2-5
2.3 Installation
The VoxBox is delivered completely assembled. It is designed for mounting on a
wall close to the PBX.
2.3.1 Unpacking
Before unpacking, inspect the package, if you notice any damage, immediately
report it to your local dealer.
To unpack the VoxBox:
1. Place the package on a flat surface and open it.
2. Remove the contents of the package and place them on a clean surface.
3. Remove all packing material.
4. Inspect the contents, if you notice any physical damage, immediately
report it to you local dealer.
2.3.2 Installing the VoxBox
To install the VoxBox:
1. Mount the VoxBox on a wall close to the PBX cabinet. Use the drill
template to place the two screws.
2. Remove the side panel cover.
3. Connect the RJ-11 connector on one end of the cables to the RJ-11 sockets
on the side panel of the VoxBox. Connect the other end of the cables to
one or two analogue telephone lines on the Main Distribution Frame
(MDF) of the PBX (see Figure 2-5).
Note: Each RJ-11 socket on the side panel of the VoxBox can support up
to two analogue telephone lines.
