76
ENGLISH
OPERATIONS
How to Use Effects
There are 3 on-board DSP digital effects: Echo
37
, FLANGER
38
and FILTER
39
.To activates an effect, simply tap
the desired Effect button.
ECHO Effect -
The echo effect adds an echo to your output signal.
FLANGER Effect -
The flanger effect distorts the output signal and creates an effect similar to the frequency
phasing in and out of each other. This frequently applied effect is similar to the Phase effect,
but slightly more harmonious, emphasizes the upper pitch more and is reminiscent of a fl ying
aircraft.
FILTER Effect -
The fi lter effect tweaks the original sound to add different tonal defi nition.
•
Automatically Beat Sync
Use the Time Division Minus
30
& Plus
32
button to change the effects time in sync with the music.
When 1/4 is selected, the activated effect will modulate with every quarter beat; 1/2 signifies half beats; 3/4
signifi es three quarter beats; 1/1 signifi es one beat; 2/1 signifi es 2 beats; and 4/1 signifi es 4 beats (1 measure).
•
Manually adjust X (TIME) Parameter
During Auto Beat Sync mode, press the X (TIME) button
36
or simultaneously press the
button
30
and the
button
32
to active the manual adjustment mode. Rotate the jog wheel to adjust the parameter.
•
Adjust Y (DEPTH) Parameter
The Y parameter controls the depth, feedback or level (Dry / Wet), depending on the effect. Press the Y button
40
and rotate the jog wheel to adjust the parameter. Each time you only can adjust one parameter.
•
HOLD button
This button allows you to set and maintain any new parameters you set to the effects. Otherwise, as soon as you
don’t touch the jog wheel anymore, the parameters return automatically to the previous settings.
NOTE
: As soon as the X Parameter Button
36
or Y Parameter Button
40
are activated, the Scratch mode
is temporarily deactivated.
Vinyl and Scratching
•
Under Vinyl Mode or Auto Cue Scratch
In vinyl mode or auto cue scratch mode the inner jog wheel will simulate the behavior of a turntable. The top
surface of the wheel is touch-sensitive. Putting your hand on the wheel will stop playback, as it would on a vinyl
record. Once playback is stopped, moving the wheel back and forth will create a scratching effect, like on an
analog turntable. Under Auto Cue Scratch mode, simply touch the surface of the JOG WHEEL and player will
immediately return to the last set CUE point and playback without music interruption.
NOTE
: To activate VINYL mode, press Jog Wheel Mode Switch button
46
to the VINYL mode. To activate
AUTO CUE SCRATCH mode, press Jog Wheel Mode Switch button
46
to the A. CUE SCRATCH
mode.
MCU-300KMA (082412).indd 章節2:76
MCU-300KMA (082412).indd 章節2:76
2012/8/24 下午 05:42:26
2012/8/24 下午 05:42:26
