Voxx Electronics CA-510, Installation Instructions Manual

128-6832

1 of 16

Avoid mounting components or
routing wires near hot surfaces

Avoid mounting components or
routing wires near moving parts

Tape or loom wires under hood
for protection and appearance

Use grommets when routing wires
through metal surfaces

Use a voltmeter for testing and
verifying circuits

PROFESSIONAL INSTALLATION STRONGLY RECOMMENDED

Installation Precautions:

Roll down window to avoid locking
keys in vehicle during installation

FCC COMPLIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that may cause undesired operation.

Warning!

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CA-510 Installation Instructions

Kit Contents

(1) - CA-510 Control Module

(2) - 2 Button High Frequency Transmitters

(1) - 3 Channel Code Learning Receiver

(1) - 12  Pin Harness

(1) - Six Pin Harness

(1) - Two Pin Harness

(1) - 2 Pin Door Lock Harness

(2) - 30 Amp In-line Fuse Holders With Fuses

(1) - Control Switch

(1) - Programming Switch

(1) - Ring Terminal

(4) - 1/2" Long Screws

(1) - Pin Switch

(1) - Remote Start Warning Label

(1) - Literature Package

Note:

 Do not install this system on a vehicle

that is not equipped with the following:

• Automatic Transmission
• Fuel Injection
• Ignition / Shift Interlock

    Technical Support
    

 For Authorized Dealers  - (800) 421-3209