16
ca1155E rev B.
Manual Feature Programming - Feature Bank 4 & 5 - N/A
Reserved for future expansion
Shock Sensor Programming, Adjustment and Testing - Feature Bank 6
1.
Turn the ignition ON.
2.
Press and hold the valet/override button.
3.
Within 10 seconds the system will chirp (3) three times.
4.
Use the valet/override button to advance through each option bank. For Shock
Sensor Adjustment advance to Feature Bank 6, which is (8) eight chirps.
5.
Turn the ignition OFF, exit the vehicle and close all doors.
6.
Select Auto-Learning or Manual Adjustment:
Option (a) Auto-Learning
a1. Press and hold the transmitter
button until the system emits 2
long chirps to enter Shock Sensor Auto-Learning Mode.
a2. Strike the vehicle to set the level intended for the system to trigger.
a3. The system will store the setting, chirp 1 time and automatically
advance to step 7, Manual Adjustment and Testing.
Option (b) Manual Adjustment
b1. Press and hold the transmitter
button until the system emits 1
long chirp to advance to step 7, Manual Adjustment and Testing.
7.
Manual Adjustment and Testing. Adjustment and testing can be performed at
any time during this step. During testing 3 short chirps indicates warn-away, 1
long chirp indicates full trigger. Allow 3 sec. between each adjustment / test.
a. Full trigger – Press the transmitter button to increase
sensitivity. Press the button to decrease sensitivity.
b. Warn-Away – Press the
button to increase sensitivity. Press
the button to decrease sensitivity.
8.
Programming will exit by turning the ignition ON or if there is no activity for 60
seconds. The system will flash the parking lights 3 times to confirm exit.
Note:
Sensitivity ranges from 0 (OFF) – 27 (most sensitive), the default setting is 4.
The system will chirp when sensitivity is raised or lowered with 2 chirps indicating the
highest or lowest setting.
Defaulting the Shock Sensor:
Enter Feature Bank 6, step 6 and press and hold the
UNLOCK button for 3 seconds, the system will emit 1 long chirp to confirm reset and
will return to step 6. Continue with step 6 or exit programming.