128-9452
Page 7
Page 7
1 2
Lock Button
Press once to lock and arm alarm.
Press and hold 3 seconds for panic
alarm where applicable.
Unlock Button
Press once to unlock and disarm alarm.
Press and hold 3 seconds for panic
alarm where applicable.
Trunk / Start Button
Press two times in succession to
start vehicle. Press and hold for
3 seconds for Trunk release
Press and release to activate
option 1 device where added.
OPTION 1
Press and release to activate
option 1 device where added.
OPTION 2
The one way transmitter included with this kit operates in a similar fashion as the two way trans-
mitter with respect to the buttons and are shown below for your reference.
(Alarm Systems Only) Push-Button LED Receiver Valet/Override/SafetySwitch
The Push-Button LED switch located in the receiver allows you to temporarily bypass all alarm
functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics.
When the system is in valet mode, all alarm functions are bypassed, however the remote panic
feature and remote door locks will remain operational. To use the valet mode, the system must
first be disarmed either by using your keychain transmitter, or by activating your personalized
manual override code.
1. Enter the vehicle, and turn the ignition key to the on position.
2. Press and hold the Push-Button switch until the LED turns on solid. The system will remain in
the valet mode.
3. To return to normal operation, press and release the Push-Button switch any time the ignition
is on.
NOTE:
Always remember to return the vehicle to the valet off position. This will ensure that the
vehicle remains protected at all times.
(Alarm Systems Only) Manually Overriding Your System:
USING THE RECEIVERS PUSH-BUTTON OVERRIDE SWITCH
Your Security System can be disarmed without the use of the keychain transmitter. This is nec-
essary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery
fails. If your system has been selected for Valet Switch manual override as indicated on the last
page of this manual, to bypass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 5 seconds, press and release the push-button override switch.
The alarm system will stop sounding and enter the (bypassed) mode. You can now start and
operate the vehicle normally.
Typically this override mode is used only if the transmitter has become inoperative.
