REMOTE STARTING THE VEHICLE:
The system WILL NOT start the vehicle if any one of the following situations
exist:
1. The vehicle's hood is opened.
2. The gear shift selector is not in Park.
3. The brake pedal is depressed.
1. To start the vehicle, press and release the transmitter button 2 times
within 2 seconds. The vehicle will start and remain running for the pre-
programmed 5, 10, 15, 20 minute run cycle. As a visual indication, the
parking lights will flash or remain on depending on the setting by your
installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position
(Do not try to restart the vehicle), then step on the brake pedal to disengage
the remote start. The vehicle will continue to run, but now on it's own
power.
2 - WAY TRANSMITTER CONFIRMATION:
The 2-way transmitter confirms the commands sent to the system by
illuminating the transmitter button. When the system recieves a command
from the 2-way transmitter, a signal is then sent back to the transmitter and
the transmitter's button will begin to flash. The number of flashes will
indicate the vehicle's status.
2 Flashes
Vehicle recieved command
1 Flash every 8 seconds
Vehicle is remote started
4 Flashes
Vehicle did not start
