128-9353
8 of 16
Page 8
NOTE:
This output can be selected to operate like the door unlock output as set in
alarm feature setting #1 by selecting feature #17 of Bank 3 to “As Bank 2 Feat
1” door unlock pulse”.
4) Black/LT. Green Wire:
Pulsed Ground Output After Start
The Black/LT. Green Wire will provide a 1 second 250 mA pulsed ground output after
the vehicle is started under control of the remote start unit. Typically this wire will be
used to re-lock the vehicle doors if the doors unlock automatically when the factory
antitheft system is disarmed.
5) LT. Blue Wire:
Ground Output While Running Under Remote Start Control
This wire provides a 250mA ground output that becomes active 2 seconds before the
Remote Start module initializes and remains grounded while the module is active plus
an additional 1 second after the system turns off. In all of the applications described
below, a relay will be required.
The LT. Blue Wire can be used to accommodate the following situations:
A. Shock Sensor By Pass:
B. Additional Ignition Output:
C. GM VATS Key Override:
6) Green w/ Yellow Wire:
Diesel Wait To Start Input
The Green w/Yellow Wire, when connected to the wire that get +12 Volts during the glow
plug preheat stage will delay the starter output until this wire drops the 12 Volts. In other
words, in a Diesel vehicle with glow plug preheat circuit, when the ignition is turned on,
the vehicle will not crank until the glow plugs are hot enough to fire the atomized fuel oil
when injected into the cylinder. By connecting this wire to the glow plug +12 Volt wire,
when the remote start unit activates the ignition one output, the glow plug output also
activates. The remote start sees the Green/Yellow with positive voltage and waits for
this to go inactive ( drop the 12 Volts) before activating the starter motor. If this wire is
not used or you have difficulty accessing the glow plug preheat circuit, you may elect
to utilize the Diesel timed output as specified in Remote Start feature selection Bank
3 Feature #11.
NOTE:
If Green/Yellow is used, it will override or negate any setting of Bank 3 feature #11.
7) Brown Wire:
Brake Positive Inhibit Input
The Brown Wire provides an instant shutdown for the Remote Start Control module
whenever it gets +12 Volts. If the Brake lights switch in the vehicle sw12 Volts
to the brake light circuit, connect the Brown Wire to the output side of the brake switch.
This will allow the Remote Start to shut down if an attempt is made to operate the vehicle
without the key while running under the control of the Remote Start. In most vehicles,
in order to shift into gear, the brake pedal must be depressed. The brake input will in
turn cause the remote start unit to shut off.
8) Gray Wire:
Negative Inhibit Input
The Gray Wire provides an instant shutdown for the Remote Start Control Module
whenever it is grounded. Connect the Gray Wire to the hood pin switch previously
installed.
This wire must be routed through a grommet in the firewall and connected to the hood
pin switch. If the pin switch is to be used with an alarm system, connect this wire using
a diode assembly.
DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM
THE OPERATION OF THE HOOD PIN SAFETY SHUT DOWN FEATURE.
