i2 MICRO iCON USER MANUAL
VPC
07/23/21
For more information visit vpc.com
6
ITA COVER INSTALLATION
PART # 410 130 XXX
TOOLS REQUIRED
Phillips Head Screwdriver
Flat Head Screwdriver
INSTALLATION INSTRUCTIONS
1. With the needed wires/contacts installed in the i2 Micro iCon
ITA/module, distribute the wires evenly around the drive shaft
(
Figure A
).
2. Place the cable bundle in the u-shaped cable clamp portion
of the cover and position the cover against the wiring side of
the ITA/module (
Figure B
).
3. With the cover against the wiring side of the ITA/module, slide
the cover down so that the slot for the cover insert clears the
bottom of the ITA/module (
Detail A
in
Figure C
).
4. Slide the insert into the cover in the orientation shown
(
Figure C
).
Continued on next page...
Figure B. Position cover.
Figure A. Distribute wires evenly around drive shaft.
Figure C. Slide cover down and install insert.
