VPC i2 MICRO iCON, User Manual

i2 MICRO iCON USER MANUAL

VPC

07/23/21

 For more information visit vpc.com

RETURN TO INDEX

9

TOOLS REQUIRED

Phillips Head Screwdriver

Flat Blade Screwdriver

RECEIVER INSTRUCTIONS

1.   Remove the strain relief or keying pins (refer to page 11 of 

this user manual) if needed. 

2.  Using the Phillips head screwdriver, remove the four panel 

mounting screws from the top and bottom of the i2 Micro 

iCon receiver 

 (

Figure A

). 

3.  Using the flat head screwdriver, remove the two flat head 

assembly screws from the back of the receiver (

Figure A

).

4.  Insert the flat blade screwdriver into the slot on the top of 

the receiver and pry the end of the receiver using a twisting 

motion until visible separation is indicated. Repeat on the 

opposite end of the receiver. 

5.  Grasp the receiver halves and apply force in opposite 

directions, rocking the ends of the receiver while slightly 

pulling the front of the receiver away from the mating 

back section. Be sure to open both sides of the receiver 

simultaneously or contacts could be damaged.

6.  Extract the signal contact per the QuadraPaddle User 

Manual. Reference contact part # 610 138 200 for receiver 

part # 310 130 101 or contact part # 610 138 216 for receiver 

part # 310 130 102.

For Hybrid Receivers (Part # 310 130 104 or 310 130 105):

7.  Extract the power contact per the Micro Power User Manual. 

Reference contact part # 610 142 101.

8.   Extract the Coax contact per the Micro Coax User Manual. 

Reference contact part # 610 140 XXX.

ITA INSTRUCTIONS

1.  Refer to page 5 for i2 Micro iCon ITA cover removal 

instructions. 

2.  Extract the signal contacts per the QuadraPaddle User 

Manual. Reference contact part # 610 138 109 or 610 138 112.

For Hybrid ITA (Part # 410 130 104):

3.  For extraction, use the Micro Power/Micro Coax extraction 

tool part # 910 112 127.  Extract the power contact per the 

Micro Power User Manual. Reference contact part # 610 143 

101.

4.   For extraction, use the Micro Power/Micro Coax extraction 

tool part # 910 112 127.  Extract the coax contact per the 

Micro Coax User Manual. Reference contact 

part # 610 141 XXX.

Figure A. i2 Micro iCon Receiver separation.

CONTACT REMOVAL

PART # 310 130 XXX, 410 130 XXX

Panel Mounting 

Screws

Assembly 

Screws

Figure B. i2 Micro iCon Hybrid receiver separation.

Panel Mounting 

Screws

Assembly 

Screws