i2 MICRO iCON USER MANUAL
VPC
07/23/21
For more information visit vpc.com
10
Figure A. i2 Micro iCon receiver strain relief.
TOOLS REQUIRED
Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS
1. Using the Phillips head screwdriver, fasten the strain relief to
the back (wiring) side of the i2 Micro iCon receiver with the
2-56 screws and nuts provided (
Figure A
). Place the nuts in the
keying positions from the front side of the receiver.
NOTE:
If using the keying features, replace the 2-56 nuts with
the keying pins (
Figure B
).
2. Torque screws to 2 in-lbs [0.23 Nm].
NOTE:
Four wiring ties are included with the strain relief for
restraining wires.
RECEIVER STRAIN RELIEF ASSEMBLY
PART # 310 113 559
Figure B. i2 Micro iCon receiver strain relief with keying pins.
