i2 MICRO iCON USER MANUAL
VPC
07/23/21
For more information visit vpc.com
13
KEYING PIN KIT, RECEIVER AND ITA ASSEMBLY
PART # 310 113 461
TOOLS REQUIRED
Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS
1. Determine the keying pin’s desired orientation (
Figure A
).
2. Using a Phillips head screwdriver, secure a keying pin in
the i2 Micro iCon receiver with the 2-56 screws provided
(
Figure B
). Torque screws to 2 in-lbs
[0.23 Nm].
NOTE:
If the strain relief plate, Part # 310 113 559 is being
used, replace the screws used to secure the keying pins
with the screws included with the strain relief plate.
3. Remove the i2 Micro iCon ITA cover (see page 5 of this user
manual).
4. Using a Phillips head screwdriver, secure a keying pin in
the ITA with the 2-56 screws provided (
Figure C
).
Torque screws to 2 in-lbs [0.23 Nm].
5. Replace the ITA cover (see page 5 of this user manual).
Figure A. i2 Micro iCon receiver and ITA mating faces. In order to mate the
connector, the keying pin must be in the same numeric position in both the
receiver and ITA.
Figure B. i2 Micro iCon receiver with keying pins.
Figure C. i2 Micro iCon ITA with keying pins.
The iSeries keying kit includes two pins and screws
which provide six different keying options. The i2 Micro
iCon is designed to accept two kits which increase the
keying options to 36.
