23- Decoration / Aufkleber
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors. Arrange sticker on model and when satisfied
adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model
surface with the tip of the knife or sharp pin and squeeze out the air. At curves stretch sticker and apply a little
heat so that no ceases occur. Cut off the excess that is produced.
L/R
1
L/R
CA
2
YELLOW SCHEME
Sticker
L/R
Sticker
Sticker
VQA037Y
YELLOW SCHEME
L/R
Sticker
WHITE SCHEME
L/R
Sticker
Sticker
CA
Antenna (plywood)
VQA037W
VQA037Y
VQA037Y / VQA037W / VQA0371
VQA037Y / VQA037W / VQA0371
