All details are subject to change
without notice !
Technische Anderungen und Irrtumer
vorbehalten !
BEFORE FLYING CHECK EVERYTHING
Before each flight, inspect the airplane for any loose parts. Check the hinges, make sure the pushrods are still firmly
attached, and check the engine mounting bolts. In general, check everything on the plane that might possibly come
loose.
CHECK THE FREQUENCE BEFORE FLYING
DO NOT FLY NEAR A POWER LINE
The power lines cause radio interference, so avoid flying near them.
Adjust the engine always from behind, but never from infront or the sides as rotating propeller may badly injure you!
Do not allow watching people to get too close to a rotating propeller.
Ensure the spinner and propeller are securely attached. Immediately disure defective propeller as well as deformed
spinners.
Be sure to keep an adequate supply of fuel in the tank. Don’t continue to fly the model until the tank is drained dry.
Never fly directly over people or fly directly towards people.
This model is highly pre-fabricated and can be built in a very short time. However, the work which you have to carry
out is important and must be done carefully. The model will only be strong and fly well if you complete your tasks
competently - so please work slowly and accurately.
SAFETY NOTES AND WARNINGS RELATING TO MODEL AIRCRAFT POWERED BY GLOWPLUG ENGINE
Always take off and landing your airplane into the wind.
Fully extend the transmitter and receiver antenna.
Switch off the transmitter and receiver after landing.
Ensure the airfield is spacious enough.
WARNING !
Do not put in a large-than recommended engine. A bigger engine does not necessarily mean better performance.
IMPORTANT:
Please do not clean your model with pure alcohol, only use liquid soap with water or use glass cleaner
to clean on surface of your model to keep the colour not fade.
