Plastic control horn
2x25mm screw
............................1
.......................2
Plastic back plate
...........................1
10mm
When you are satisfied with the
alignment of the control horn, mark
the mounting hole positions with a
felt tipped pen or a pencil.
Remove the control horn and drill
two 2mm (5/64”) holes through the
rudder
Insert the rudder push rod into the
rudder control horn. Attach the rudder
control horn using two 2x25mm screw
and a back plate.
20- Linkages / Anlenkungen
2x25mm screw
Rudder servo
2 mm
X
CA
X
CA
2 mm
Connector
Elevator push rod
Linkage stoper
Throttle push rod
Included with the
radio set
TOP VIEW
Draufsicht
Magnetic cockpit deck
21- Cockpit
TOP VIEW
Draufsicht
Throttle pushrod
Elevator pushrod
Tank
19- Linkages / Anlenkungen
Rudergestange
