2x8mm screw
2x8mm screw
1.2mm
1.2mm
...................6
Cotton thread
(not include)
GEAR DOOR IN CLOSED POSITION
(NOSE RETRACT LANDING GEAR
IN RETRACTED POSITION)
GEAR DOOR IN OPENED
POSITION
(RETRACT LANDING GEAR IN
EXTENDED POSITION)
Hinge
Fuselage
side
Gear door
CA
GEAR DOOR
IN OPENED
POSITION
Cotton thread
30-Canopy
Putt Putt Maru version
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors. Arrange sticker on model and when satisfied adhere the corner without
backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface with the tip of the knife
or sharp pin and
squeeze out the air. At curves stretch sticker and apply a little heat so that no ceases occur. Cut off the excess that is produced.
U
R
A
M
T
T
U
P
T
T
U
P
T
T
U
P
T
T
U
P
U
R
A
M
“Putt Maru” decal is
only for one side
Kill-mark only
for one side
31-Decal
29-Gear door
