VRX Racing RH816, Instruction Manual

Notes on Battery use:

WARNING!  NEVER LEAVE THE BATTERY  UNATTENDED WHILE ON CHARGE.

.

Charging/Installing the Battery

Always store your model with the battery pack unplugged and removed. Always charge your battery away  from the vehicle.

The supplied charger can charge either 2s or 3s (cell number) Lipo batteries.The supplied 

battery is a 3s ensure you plug it  into the correct 3s balance port.

When the charger is connected to the mains powers the power LED will turn green. Once your

connect your balance connector to the charge the status LED will turn red indicating that

charging is in progress. Once the battery is fully charged the status LED will turn green. If you 

experience the LED blinking red then there is an error with either the battery or charger. 

When charging a completely discharged battery, the charger can become hot to touch. NEVER 

LEAVETHE BATTERY CHARGE UNATTENDED

。

Always disconnect the charger from the 

mains supply and the battery pack when not in use.

To   install a charged battery, firstly remove the body shell and insert the battery into the battery 

case, then fasten the two Velcro straps to fix the battery stably. When connecting battery and 

turning car on, ensure it is off ground with wheels away from objects.  

Always allow the battery cool after use, before recharging.

Always inspect the battery before charging.

Any bare wires, split heat shrink or leakage is a sure sign of abuse.

Never attempt to charge dead or damaged batteries.

Do not disassemble the battery or cut the connector wires.

If the battery connector,battery case or cable insulation get hot enough to melt or split there is most likely a serious problem with

your model,battery wires or speed controller.Find and correct the problem before installing another charged battery pack.

NEVER charge the battery unattended incase of overcharging, you need to be able to monitor the battery during charging.

Charge away from flammable objects and on a non-flammable surface incase the battery becomes too hot.

Aerial Assembly  

As the aerial wire on 2.4GHz system is so short you do not need to protrude through the body shell and it can be left to stand 

directly from the receiver. If you want the security of an aerial tube away simply cut it short, and insert in the usual way but do NOT 

bend over the last 5mm of aerial wire to retain it under the rubber cap, last two inches of aerialwire need to be straight with no kinks 

for maximum range and control with 2.4GHz system.

First be sure to insert the wire up through the receiver cover hole as below. Push the wire all the way through the aerial tube until 

the first 5mm of wire shows out of the other end. Finally make aerial tube firmly seated.