THE LITHIUM CUT / TOOL TIPS
7
PREPPING YOUR
NEW TOOL
CHARGING
The Lithium Cut clipper is so easy to use. But before you start using your new tool,
you must take the time to charge it overnight for
3 hours
before its first use. Your
new tool comes with a small amount of charge, but the initial charge will ensure
your new tool will have optimum power performance to give you smooth fast
cutting, every time.
- Before using for the first time, fully charge your new tool continuously for 3
hours.
- Maximum battery capacity will only be reached after 3 charging & discharging
cycles.
- Ensure your new tool is switched off.
- Insert the small plug on the charging adaptor into the socket on the bottom of
your new tool.
- Plug the charging adaptor into a suitable mains power socket and switch on.
- The red charging LED indicator light on your new tool will flash when correctly
connected to the mains power,and will continuously flash until the battery has
fully charged.
- When the battery is fully charged ,the LED indicator light will stop flashing,but
remain on.
- A full charge of 3 hours will supply 75 minutes cordless runtime.
- A quick charge of 15 minutes will supply 15 minutes cordless runtime.
- When the clipper is running low on charge, the LED indicator light will flash,
warning you there is approximately 3 minutes left of battery use remaining.
- lf the charging light suddenly starts to flash rapidly (more than 4 flashes per
second) then the appliance is faulty. lf this happens then plesae stop charging
and remove the adaptor from the mains and contact our customer care centre for
further advise(see the “warranty section” section of the information booklet).
