FLOW-meter Version: 1.0
Page 20/29
2.4.2
Parameter "FLOW.TXT"
Not relevant for Futaba
Start-ID:
Here, the sensor ID will be set at which the sensors of FLOW-meter are
registered at Futaba system.
The ID applies to the first Temperatursensor SBS-01T (FLOW), the second
Temperatursensor SBS-01T (FUEL%) then has the Sensor-Start-ID + 1.
A change in the sensor ID can still take place if further SBUS sensors are
registered on the transmitter with randomly the same sensor ID - or even another
FLOW-meter, for example, in a 2- rayed Jet.
Slot …:
Here, the StartSlot of each individual sensor can also be set manually: in the
transmitter, the assigned sensor is also to be set manually at the corresponding
slot address (SBS-01T bzw. Temperature).
The
corresponding
sensor
is
deactivated
with
slot
"OFF"
- is thus also deactivated for transmitter registry.
Reset Servo:
A servo channel can be set here that will reset the FUEL value at > 80% via the
SBus2. The 1-pin patch cable described in section 1 Hardware can therefore be
omitted here.
=================================================
********** settings Vspeak FLOW-meter **********
=================================================
set value|value range |unit |description
=================================================
general
-------------------------------------------------
5000 |50...20000 | |Pulses/1000ml
3000 |200...20000 |ml |FUEL Tank Size
consumed |consumed, level | |FUEL display
10 |1,5,10,20,50,100 | |FUEL rounded
Power ON |Power ON, OFF | |Auto Reset
alarms
-------------------------------------------------
OFF |OFF,50...2500 |ml |FUEL Reserve
OFF |OFF,10...500 |ml/min |Flow MIN
.
.
.
Futaba
-------------------------------------------------
2700 |2700...2800 step10 |Start ID
OFF |OFF,1...31 |FLOW |Slot SBS01T
23 |1...31 |FUEL % |Slot SBS01T
OFF |OFF,1...16 | |Reset Servo
(excerpt section 2.0.2)
