SERVICE and INSPECTION RECORD
Date
Damage observed Repair
Comments next due date
Name and Signature of competent person
Check the state of the connector before every use:
ensure that it is in a serviceable condition and operates correctly (locking/opening); no deformation, no corrosion, no damage. Product
markings must remain legible. In the event of doubt regarding the condition of the device, or after a fall, the lanyard must not be reused,
should be withdrawn from service (marking it with the words “DO NOT USE” is recommended) and must be returned to the manufacturer or
to a qualified person appointed by the manufacturer.
Do not remove, add or replace any component of the connector.
SUITABILITY FOR USE:
The connector must be used as part of a fall arrest system as defined in the product data sheet (EN363) to guarantee that the dynamic force
exerted on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body gripping device that may be used. A
harness should be connected to a fall arrest system by EN362 connectors. Attachment points that are not marked A or A/2 must not be used
for connecting a fall prevention device. It may be dangerous to create one’s own fall arrest system where each safety function can interfere
with another safety function. Read the recommendations on using each component in the system before use.
VERIFICATION PROCEDURE:
The equipment has a service life of 12 months (in accordance with the annual examination by a competent person authorized by VIRAJ), but
this duration may increase or decrease depending on how it is used and/or the results of annual checks.
The equipment must be checked systematically in case of doubt or after a fall and at least every year by the manufacturer or his competent
person , to guarantee its state and thus the safety of the end-user. The product data sheet should be completed (by writing) after each
verification, date of inspection and date of next inspection must be indicated on the data sheet, it is also recommended to put date of next
inspection on the product.
SERVICING AND STORAGE: (Comply strictly with these instructions)
During transport, keep the connector in its packaging, well away from any cutting surface. Clean it with cotton cloth or soft brush. Do not use
any abrasive material water. The metal parts should be wiped with a cloth impregnated with paraffin oil. Never use bleach or detergents. The
connector should be stored in its packaging in a warm, dry, ventilated place, protected from sunlight, heat and chemicals.
SF-1102
SECUREFIRST
CE 2233 23KN EN362:2004 B
Marking
a) Product reference
b) Indication of conformity with the directive
c) Number of the certifying organization responsible
for inspecting the equipment
d) Manufacturers name
(a)
(e)
(g) (h)
(f)
(b)
(d)
e) The minimum resistance of the product in KN
f) The number of the standard to which the product
conforms and its year
g) The class of the connector
h) Read the instruction before use
