30
Step 2: select the module required to be started when conditions are satisfied
Click on a certain module in the list box and click on << button, to add this module into the
result list area. Except for "manual control panel linkage setup", a linkage condition can be used
to start multiple modules, therefore step 2 and step 3 can be repeated to add multiple output
results.
The modules started by a condition are limited in number and a condition can be used to
start 200 modules at most. If the number exceeds 200, the user must set another different
number with the same conditions, to correspond to modules with numbers exceeding 200.
Check a module in the “Result list” and click on >> button to delete the module from the
result list.
The display of result output column in the figure is as follows:
Figure 4-34 Output result
If it is indicated that the linkage condition is true, two modules (module 1 and module 2) will
be requested for action. The two modules control fire pumps.
In the linkage interface, only the module address number can be
selected, the equipment controlled by the module shall be set at the
detector/module setup form.
Step 3: confirm
Press Confirm button and the system will save the linkage condition and exit the linkage
setup interface. Press Add, Next or Prev to switch to another linkage condition setup interface to
proceed. At switching over, the system will save the linkage conditions set just now.
The setup of a linage relation is completed after conducting the above 4 steps. The
following section will present respective diagrams.
The operation of "delay" drop-down box is as shown in the following figure:
Figure 4-35 Delay selection
There are 8 time selections for delay: 0s, 5s, 10s, 30s, 60s, 90s, 120s and 150s.
Selection of input type, as follows:
