vSync924 & 1624i User Guide
© vSync DVR December 2007
Rev A.
December 2007
Specifications and content are subject to change without notice.
52
8. Remote Setup Using
Embedded Web-Server
of
vSync924i & 1624i
******** Requires Configuring Network Settings in Section 3-7 *************
vSync
client software provides a remote web interface to access most setup parameters. Please note that
Schedule and Motion Zone setup parameters
are not supported
via the web interface.
To connect to the admin page over the web you can either click on the
“Magic Wand/Admin”
button
in the
vSync
client program or type
http://ip-address:http-port/admin.htm
in Microsoft Internet Explorer.
(ex:
http://xxx.xxx.xxx.xxx/admin.htm
)
(Only Microsoft Internet Explorer is supported, we do not support other third-party browsers, i.e. FireFox.)
Before loading the admin page, the browser will prompt for the User ID and Password.
The default values are “root” and “dw2001,” respectively.
See Figures below for examples of Setup pages for each category. After setting all the parameters for each
page,
make sure to press the APPLY button at the bottom of the page to temporarily store these
settings.
After inputting all setup values, go to the “
Save Setup
” menu and press the
SAVE
button. The system will
reboot to allow the new parameters to take place.
To protect your DVR from unauthorized use, we strongly recommend changing the User ID and
Password.
