EN - 21
En
g
lish
To program a Speed Dial key on the cordless handset:
1. Remove the faceplate and overlay if they are on the telephone base. Then press the recessed
PROGRAM
key.
2. Press 61, 62 or 63 for the desired Speed Dial key where the telephone number is to be stored (61
indicates the Speed Dial key below
SPEAKER
key, 62 indicates the Speed Dial key below
HOLD
key and 63 indicates the Speed Dial key below
MUTE
key) and you hear 3 beeps.
3. Enter the telephone number (up to 32 digits).
• To insert a pause in the stored number, press the recessed
PAUSE
key.
4. The telephone stores the number automatically when 32 digits are entered. When the number
has less than 32 digits, press the recessed
PROGRAM
key again. You hear 3 rising beeps as
confirmation.
To clear the programmed Speed Dial key:
1. Remove the faceplate and overlay if they are on the telephone base. Then press the recessed
PROGRAM
key.
2. Press 61, 62 or 63 for the desired Speed Dial key where the telephone number is to be deleted (61
indicates the Speed Dial key below
SPEAKER
key, 62 indicates the Speed Dial key below
HOLD
key and 63 indicates the Speed Dial key below
MUTE
key) and you hear 3 beeps.
3. Press the recesse
d
PROGRAM
key again. You hear 3 rising beeps as confirmation.
When a NGC-C5101 is registered to a NG-A3411 telephone base, you can program these keys using
the telephone base or share the same Speed Dial numbers with the telephone base.
To enable the Speed Dial number sharing from the telephone base:
1. Remove the faceplate and overlay if they are on the telephone base. Then press the recessed
PROGRAM
key.
2. Press 03 and you hear 3 beeps. Then press 1 to enable. You hear 3 rising beeps as confirmation.
If you program a different set of Speed Dial numbers to the accessory handset, you must disable the
Speed Dial number sharing before you can program the Speed Dial numbers.
To disable the Speed Dial number sharing from the telephone base:
1. Remove the faceplate and overlay if they are on the telephone base. Then press the recessed
PROGRAM
key.
2. Press 03 and you hear 3 beeps. Then press 0 to disable. You hear 3 rising beeps as confirmation.
