Using the WebUI
54
VCS752 Administrator and Provisioning Manual
Network Pages
You can set up the VCS752 for your network configuration on the Network pages. Your
service provider may require you to configure your network to be compatible with its
service, and the VCS752 settings must match the network settings.
The network settings are also available as parameters in the configuration file. See
“"network" Module: Network Settings” on page 106
.
After entering information on this page, click
to save it.
Basic Network Settings
Basic Network Settings
Click the link for each setting to see the matching configuration file parameter in
Module: Network Settings” on page 106
. Default values and ranges are listed there.
If you disable DHCP on this page, you must configure static IP settings for the
VCS752. You must be familiar with TCP/IP principles and protocols to configure
static IP settings.
Setting
Description
DHCP is selected (enabled) by default, which means the
VCS752 will get its IP address, Subnet Mask, Gateway, and
DNS Server(s) from the network. When DHCP is disabled,
you must enter a static IP address for the VCS752, as well
as addresses for the Subnet Mask, Gateway, and DNS
Server(s).
Static IP
When Static IP is selected, you must enter a static IP
address for the VCS752, as well as addresses for the
Subnet Mask, Gateway, and DNS Server(s).
If DHCP is disabled, enter a static IP address for the VCS752.
Enter the subnet mask.
Enter the address of the default gateway (in this case, your
router).
