Configuration File Parameter Guide
140
VCS752 Administrator and Provisioning Manual
"page_zone" Module: Paging Zone Settings
The paging zone settings allow you to define a maximum of 10 paging zones that the
VCS752 can use for multicast paging.
The paging zone parameters (except for page_zone.call_priority_threshold) follow the
format page_zone.x.[element], where x is the paging zone ID number, ranging from 1 to 10.
All the paging zone settings are included in the general configuration file.
Setting:
page_zone.x.name
Description:
Sets the paging zone name, which appears on VCS752 LCD for outgoing
and incoming multicast pages. A maximum of 15 characters is allowed.
Values:
Text string
Default:
Blank
Setting:
page_zone.x.multicast_address
Description:
Enter the multicast IP address that the VCS752 will monitor. The range of
valid IP addresses is 224.0.0.0 to 239.255.255.255.
Values:
IPv4 IP address
Default:
Blank
Setting:
page_zone.x.multicast_port
Description:
Enter the multicast port associated with the multicast IP. The range of
valid ports is 1 to 65535.
Values:
1–65535
Default:
Blank
Setting:
page_zone.x.accept_incoming_page
Description:
Enables or disables the VCS752 from receiving incoming multicast
pages for that paging zone. If disabled, the VCS752 can make outgoing
multicast pages only.
Values:
0 (disabled), 1 (enabled)
Default:
1
Setting:
page_zone.x.priority
Description:
Set the paging zone priority from 1 to 10. Zones with a priority higher than
another zone can interrupt the lower-priority zone's active page.
Values:
1–10
Default:
5
