Using the WebUI
110
VSP716A Administrator and Provisioning Manual
Trusted IP
In addition to the Trusted Servers setting, incoming IP traffic can be filtered using an
"Allowed IP" list of IP addresses. When this means is enabled, all unsolicited IP traffic will
be blocked unless it is from one of the trusted IP addresses on the "Allowed IP" list.
Yu can enter the "Allowed IP" list in the 10 fields on the "Trusted IP" section. Entries on the
"Allowed IP" list must be specified as IP addresses (IPv4 or IPv6).
Three formats are supported for entries on the "Allowed IP" list:
1. IP range specified using CIDR notation (defined in rfc4632). IPv4 or IPv6 address
followed by a prefix; for example, 192.168.0.1/24.
2. IP range specified with a pair of starting and ending IPv4 or IPv6 addresses, separated
by '-' (for example, 192.168.0.1-192.168.5.6).
No space before or after '-'
Both starting IP & ending IP have to be with the same IP version
Starting IP has to be smaller than the ending IP; otherwise, all traffic will be
dropped.
3. Single IP address in IPv4 or IPv6.
To ensure WebUI access after configuring Trusted IP, you must include the IP of
the Web Browser on the "Allowed IP" list.
Setting
Description
Enable or disable using the “Allowed IP” list to filter all IP
traffic.
Enter IP addresses or address ranges to be used as
sources of authorised IP traffic.
