Configuration File Parameter Guide
198
VSP716A Administrator and Provisioning Manual
softkey Module: Custom Soft Key Settings
The custom soft key settings allow you to select which soft keys can appear on the Idle
screen, the Call Active screen, the Call Held screen, the Live Dial screen and the Transfer
Setup screen. You can also specify the position of each soft key. Softkeys appear on the
VSP716A screen in the same order as the softkey values you enter. Enter soft key values
separated by commas. For more information, see
“Customising Soft Keys” on page 20
. You
can specify a maximum of nine soft keys (three levels) for each parameter.
The soft key settings follow the format softkey.[element].
All the soft key settings are included in the general configuration file.
Setting:
softkey.idle
Description:
Specifies the soft keys visible on the idle screen.
Values:
blank, dir, call_log, redial,
message, dnd, cfwd, cfna,
cfwd_all, cfwd_busy,
intercom, retrieve, callback,
grp_pickup, dir_pickup, line,
settings
Default:
dir,redial,call_log,cfwd,
message,dnd,line
Setting:
softkey.call_active
Description:
Specifies the soft keys visible on the active call screen.
Values:
blank, new, park_call, end,
hold, pri_hold, transfer,
conf, flash
Default:
end,hold,transfer,conf,
priv_hold
Setting:
softkey.call_held
Description:
Specifies the soft keys visible on the held call screen.
Values:
blank, new, retrieve,
grp_pickup, dir_pickup,
end, resume, transfer, conf,
hs_pick
Default:
end,new,resume,transfer,
conf,hs_pick
Setting:
softkey.live_dial
Description:
Specifies the soft keys visible on the live dial screen.
Values:
blank, dir, call_log, redial,
message, end, dial, input,
cancel, backspc
Default:
backspc,input,dial
