Configuration File Parameter Guide
205
VSP726 Administrator and Provisioning Manual
system_event Module: Action URI Settings
You can enter Action URIs to allow the VSP726 to interact with a server application by using
an HTTP GET request. The action URI triggers a GET request when a specified event
occurs. Action URIs allow an external application to take control of the display when an
event occurs. For more information, see
“Server Application” on page 80
All the Action URI settings are included in the general configuration file.
Setting:
system_event.startup.action_uri
Description:
Enter URI for GET request triggered at end of phone bootup.
Values:
Text string
Default:
Blank
Setting:
system_event.registered.action_uri
Description:
Enter URI for GET request triggered at end of line registration.
Values:
Text string
Default:
Blank
Setting:
system_event.on_hook.action_uri
Description:
Enter URI for GET request triggered when phone goes from active to idle.
Values:
Text string
Default:
Blank
Setting:
system_event.off_hook.action_uri
Description:
Enter URI for GET request triggered when phone goes into dial mode.
Values:
Text string
Default:
Blank
Setting:
system_event.incoming_call.action_uri
Description:
Enter URI for GET request triggered for incoming calls or call waiting
events.
Values:
Text string
Default:
Blank
Setting:
system_event.outgoing_call.action_uri
Description:
Enter URI for GET request triggered when phone sends SIP INVITE
message.
Values:
Text string
Default:
Blank
