Go! Go! Cory Carson
®
Fire Rescue Freddie™
Rotate the packaging lock counterclockwise
several times.
Pull out the packaging lock and discard.
Unlock the Packaging Locks
Battery Removal and Installation
1.
Make sure the unit is turned
OFF.
2.
Find the battery cover located on the bottom of
the unit, use a screwdriver to loosen the screw
and then open the battery cover.
3.
Remove old batteries by pulling up on one end
of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended).
5.
Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
•
Only batteries of the same or equivalent type as recommended are to be
used.
•
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
•
Remove rechargeable batteries from the toy before charging.
•
Rechargeable batteries are only to be charged under adult supervision.
•
Do not charge non-rechargeable batteries.
PRODUCT FEATURES
1. On/Off Switch
To turn the unit
On
, slide the
On/Off Switch
to
the
On
position. To turn the unit
Off
, slide the
On/Off Switch
to the
Off
position.
2. Automatic Shut-Off
To preserve battery life, the
Go! Go! Cory Carson
®
character will automatically
power down after approximately 30 seconds without input. The unit can be turned
on again by pressing the
Light-Up Button
, placing or removing the accessory on
the character or by rolling the character quickly.
1
2
91-003967-000
US
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not
part of this toy, and should be discarded for your child’s safety.
NOTE:
Please keep this parents’ guide as it contains important
information.
ATTENTION : Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes, cordons et vis d’emballage. Ils ne
font pas partie du jouet.
NOTE :
Il est conseillé de conserver ce guide des parents car il comporte
des informations importantes.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
